MCD Racing RR5 Manual de Instruções descarregar pdf (Página 10)

Fll the fuel tank. Use only mnmum 95 Octane gasolne mxed wth hgh qualty two-cycle engne ol.

Use a 20:1 rato gasolne to ol. (e.g. 250ml oil mixed with 5lt Fuel)

Carburetor default settings

Starting the engine

Starting the Engine

Preparing fuel

The engne s provded wth an ntegrated fuel pump to get fuel to the

carburetor. The carburetor features a manual pump (B) wth a transparent

cover to see the fuel ﬂow. Follow the steps below to start the engne.

Be sure you understand all engne nstructons before attemptng to start the engne. Turn on the transmtter

frst, then the recever before startng the engne.

1. Pump the prmer bulb on the carburetor(B n

Figure M) untl t s flled.

2. Set the choke lever(A n Figure M) as shown.

3. Pull the starter cord 3 tmes slowly for the fuel

to get n the cylnder.(Do not pull the cord fast

and more than 50-60cm)

4. Set the choke lever as shown.

5. Pull the starter cord rapdly 5-6 tmes untl the

engne starts.(Do not pull the cord more than 50-60cm)

6. When the engne starts, set the dle f ts too hgh

(vehcle moves at dle) or too low(engne stops runnng

from the dle screw shown n Figure N.

7. If the engne does not start set the carburetor to

default settngs as ndcated above.

Caution!

Figure M

Shutting the engine o

Push engne stop swtch E shown n Figure M. ( For RR5 cut the body from the ndcated

area n order to access the engine switch when the body s mounted.)

Slght adjustments of the carburetor mght be needed dependng on the external factors such as mxture,

spark plug, mufﬂer and envronmental factors(ar pressure, humdty and temperature).

Fne-tunng dle and full throttle settngs wll only work after the engne s fully broken n. The factory settngs

provde a rch mxture that results n a sgnfcant blue smoke from the exhaust.

In case the dle-mxture needle L or the man needle H were accdentally altered, turn the settng screws H

and L clockwse as far as they wll go. Afterwards, turn the H screw 1hour 30mns +- 5mns turns counter-clockwse

and the L-screw 1 hour 10mns +- 5mns counter-clockwse. (As explaned n Figure O below)

H needle

L needle

Idle Screw

Figure N

1 hour(60mns) 5mns30mns

H Needle:

1Hour 30mns

+- 5mns

+ +-

1 hour(60mns) 5mns10mns

L Needle:

1Hour 10mns

+- 5mns

+ +-

Figure O

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Comentários a estes Manuais

Sem comentários

MCD Racing RR5 Manual de Instruções Página 10

Comentários a estes Manuais