MCD Racing RR5 Manual de Instruções descarregar pdf (Página 8)

Installing the brake linkage

Durng operaton the brake pads wear over tme causng weakenng of the brakes. In order to compensate

you should extend the brake lnkage by turnng t.

1. Make sure you assemble the brake lnkages wth the dmensons as ndcated below.

2. Connect the upper lnkage to the front brake and the bottom lnkage to the rear brake as ndcated n Figure F.

3. After the lnkages are nstalled, swtch on your rado and reduce the brake end pont from the transmtter

EPA menu to %30.

4. Apply full brake from the trgger and hold.

5. By movng the car back and forth wth your hand, start slghtly ncreasng EPA to approx. %50 untll the brakes lock.

6. If t doesn’t lock at %50 turn back to the step 1 and re-adjust.

7. After the brakes are functonng properly adjust the brake bas by usng the collars as ndcated n Figure F.

8. After the step 7 s complete your brake set-up s fnshed.

Figure F

Figure G

Cut one of the suppled sprngs to 20mm.

2,5

4 6

Cut one of the suppled hoses to 2 peces of 10mm.

Rear brake adjustment collar. Front brake adjustment collar.

Adjust the brake bas 55% front and 45% rear.

Requres advanced programmable mxng 3 channel rado.

Check your transmtters manual to adjust.

Optional rear brake servo installation

Install the lnkage n ths sde f sngle servo s used.

Install the lnkage n ths sde f double servo s used.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Sem comentários

MCD Racing RR5 Manual de Instruções Página 8