MCD Racing RR5 Manual de Instruções descarregar pdf (Página 7)

Throttle and brake linkage

The throttle/brake servo controls both lnkages and serves two purposes: 1. The throttle lnkage controls

the amount of ar that goes n to the engne and therefore controls engne rpm. 2. When the throttle lnkage

stops at dle, the brake lnkage engages.

Installing the throttle linkage

12. Hold full throttle on the transmtter then ncrease throttle

EPA slowly untl there s 0,2mm gap left between the

parts shown n Figure E.

13. After ths settng leave the throttle to neutral poston.

14. The throttle lnkage s assembled and algnment s done. Check f the lnkage s functonng properly.

1. Turn on your rado frst.

2. Check f servos are functonng.

3. Be sure the servo turns on correct drecton. (Throttle drecton: CCW, Brake drecton: CW. As shown

besde. Reverse f drecton s not correct!)

4. Install servo horn.

5. Make sure you adjust neutral poston as shown n Figure A. If necessary correct the neutral poston from

the sub trm menu on your transmtter.

6. Cut the engne cover from the spot ndcated n Figure B.

7. After completng the prevous steps connect lnkage as ndcated n Figure A.

8. After adjustng the neutral poston nstall the throttle lnkage as ndcated n Figure C.

9. Make sure you leave a 0,2mm gap n between the “lnkage stopper” and “lnkage plastc” as ndcated n Figure A.

10. Reduce the throttle end pont adjustment(EPA) around %50

from the transmtter.

11. Apply full throttle from the trgger. (Figure D)

Cut the engne cover from here(6)

Neutral Poston(5)

Leave a 0,2 mm gap(9)

Cut the suppled slcone

hose to 5mm peces and

nstall here.

Figure A

Figure B

Figure E

Leave a 0,2 mm gap whle on full throttle(12)

Figure D

Figure C

Rotate the ar flter up.Screw from here(8)

Throttle Brake

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Sem comentários

MCD Racing RR5 Manual de Instruções Página 7